User manual
ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 22
Dotz TPar System Alternate Lighting Installation
Dotz TPar System Power Cord Daisy Chaining
With this feature you can connect the xtures to one another
using the IEC input and output sockets. The quantity that can be
connected is 7 xtures maximum for 120V, and 14 xtures maxi-
mum for 230V. After the maximum xtures has been reached you
will need to use a new power outlet. They must be the same x-
tures. DO NOT mix xtures.
A special feature that this system has is that you are able to mount
two light eects on top of the “T” bar. You are then able to power
those lights by plugging the power cords directly into the bar. The
power sockets are located on the right side and left side. The middle
power socket is for power cord daisy chaining. Do not use the
middle power socket to power your added lights.
To add the lights onto the top is a simple process. Make sure your “T”
bar is set up on the stand correctly and is secure. Follow the instruc-
tions below.
1. Start by unscrewing the black knob that is attached to the bolt.
2. Attach the lighting eect to the bolt using the lighting eects con-
nected bracket.
3. After you have set the bracket onto the bolt, screw the black knob
and secure the knob tightly. See the sample pictures below.
4. Plug the mounted lights into their respective power jacks.
Dotz TPar System Photometrics
0
0 1 2 3 4 5
1
1
2
2
3
Intensity(LUX)
Beam opening(m)
3
25
35
Red LEDs
Green LEDs
Blue LEDs
Full LEDs
1.08
1.45
0.65
0.83
1.83
2.10
1.97
2.70
2.41
3.35
Beam angle 25°
Field angle 35°
2400
2760
4130
8650
749
904
1357
2680
360
427
646
1345
206
249
96
372
138
161
246
506
25°
Diameter
(m)
35°
Diameter
(m)
ADJ Products, LLC - www.adj.com - Dotz TPar System User Manual Page 23