User manual

ADJ Products, LLC - www.adj.com - Inno Pocket Spot Instruction Manual Page 10
Inno Pocket Spot System Menu
ADJ Products, LLC - www.adj.com - Inno Pocket Spot Instruction Manual Page 17
Universal DMX Control: This function allows you to use a Elation®
universal DMX-512 controller to control the chases and patterns,
dimmer and strobe. A DMX controller allows you to create unique
programs tailored to your individual needs.
1. The Inno Pocket Spot has 2 DMX channel modes; 9 channel
mode or 11 channel mode. See pages 20-23 for detailed descrip-
tion of the DMX values and traits.
2. To control your fixture in DMX mode, follow the set-up procedures
on pages 5-7 as well as the set-up specifications that are includ-
ed with your DMX controller.
3. Use the controller’s faders to control the various DMX fixture traits.
4. This will allow you to create your own programs.
5. Follow the instruction on page 9 to set the DMX address.
6. For longer cable runs (more than a 100 feet) use a terminator on
the last fixture.
7. For help operating in DMX mode consult the manual included
with your DMX controller.
Sound Active Mode: This mode allows either single unit or several
units linked together, to run to the beat of the music.
1. Press the MENU button until “SOUN” is displayed, and press
ENTER. Press the UP or DOWN buttons so that “ON” is dis-
played and press ENTER.
2. Press the MENU button until “SENS” is displayed, and press
ENTER. Use the UP and DOWN buttons to adjust the sound
sensitivity. Press ENTER when you have found your desired sensi-
tivity level.
Show Mode: This mode allows either a single unit or several units
linked together, to run one of four shows that you choose.
1. Press the MENU button until “SHND” is displayed, and press
ENTER.
2. Press the UP or DOWN buttons until you nd your desired show,
and press ENTER.
Inno Pocket Spot Operation
DMX 512 Address Setting
Channel Mode
Show Mode
Slave Mode
Lost DMX Signal
Dimmer Mode
Sound Mode
Sound Sense
Pan Inverse
Tilt Inverse
LED Display
Display Normal
Display Inversion
Auto Test
Fixture Use Time
Reset
Firmware Version