User manual

ADJ Products, LLC - www.adj.com - Inno Pocket Spot Instruction Manual Page 9

5-Pin XLR DMX Connectors.

Some manufactures use 5-pin DMX-

512 data cables for DATA transmission in place of 3-pin. 5-pin DMX

xtures may be implemented in a 3-pin DMX line. When inserting stan-

dard 5-pin data cables in to a 3-pin line a cable adaptor must be used,

these adaptors are readily available at most electric stores. The chart

below details a proper cable conversion.

Conductor 5-Pin XLR Male (In)3-Pin XLR Female (Out)

Pin 1

Pin 5 - Do Not Use

Pin 4 - Do Not Use

Pin 3

Pin 2

Pin 1

Pin 3

Pin 2

Not Used

Data True (+ signal)

Data Compliment (- signal)

Ground/Shield

3-Pin XLR to 5-Pin XLR Conversion

Inno Pocket Spot DMX Set Up

ADJ Products, LLC - www.adj.com - Inno Pocket Spot Instruction Manual Page 18

Inno Pocket Spot Master-Slave Set Up

Master-Slave Operation This function will allow you to link up to 16

units together and operate without a controller. The units will be sound

activated. In Master-Slave operation one unit will act as the controlling

unit and the others will react to the controlling units programs. Any unit

can act as a Master or as a Slave.

1. Using approved DMX data cables, daisy chain your units togeth-

er via the XLR connector on the rear of the units. Remember the

Male XLR connector is the input and the Female XLR connector

is the output. The rst unit in the chain (master) will use the female

XLR connector only - The last unit in the chain will use the male

XLR connector only. For longer cable runs we suggest a termina-

tor at the last fixture.

2. On the Master unit press the MENU button until “SLND” is dis-

played, and press ENTER. Use the UP and DOWN buttons to

scroll to the “MAST” setting and press ENTER.

3. After setting the Master unit to the master setting find your

desired operating mode.

4. On the slave units press the MENU button until “SLND” is dis-

played, and press ENTER. Choose either “SL 1” or “SL 2” and

press ENTER. See page 10 for more info.

5. The slave units will now follow the Master unit.