User manual

ADJ Products, LLC - www.adj.com - Flash Kling Batten Instruction Manual Page 6

Flash Kling Batten Connections

When connecting you must use a CAT 5 Straight Network cable.

Installation method 1:

Note: Do not daisy-chain more than 50pcs LED panels from the computer,and use an Ethernet Switch if more than 50pcs LED lights are being controlled.

Note:1.The Ethernet Switch must be Gigabit Switch.

2. Do not daisy-chain more than 50pcs LED panels from a single network port of the Ethernet Switch.

3. Maximum 2 output network ports of the Ethernet Switch can be used.So the system can control 100pcs panels maximum.

Installation method 2:

ADJ Products, LLC - www.adj.com - Flash Kling Batten Instruction Manual Page 5

Flash Kling Batten Operation

Control Using Kling-net or Art-Net:

1. Install one of the recommended operating softwares onto your

computer. Recommended softwares; Arkaos Media Master

Express, Media Master Pro, or LED Master (Sold Separately).

2. Connect the panels via CAT 5 Straight Network cable. When

creating your own custom cable, use RJ45 Straight Network

cable.

3. Map the fixtures using KlingNetMapper or Art-Net Mapper.

4. Control the fixtures using ArKaos or Art-Net software. Please refer

to the media playback software user manual for further instruc-

tions.

Note: ArKaos Kling-Net requires a gigabit (1000 mbps) Ethernet card

and network router for a smoother operation.

Connecting to Power and Data:

When connecting to power, the LED indicator on the bottom of the

unit should glow a solid red if the unit is receiving power.

When the unit is receiving a data signal, the LED indicator will flash

yellow.

Note: The LED indicator may only flash when pressing the mouse and

moving the indicator arrow around in the grid.

Flash Kling Batten Daisy-Chaining Units

Do not daisy-chain more than 50 Panels when connecting directly to

a computer. To daisy-chain more than 50 Panels you must use a Eth-

ernet Switch. When using a Ethernet Switch, do not daisy-chain more

than 50 Panels from a single network port of the Ethernet Switch. A

maximum 2 output network ports of the Ethernet Switch can be used.

So the system can control 100 Panels maximum, no more. See the

directions under the connection diagrams on page 6.

With this feature you can connect the xtures to one another

using the IEC input and output sockets. The quantity that can be

connected is 12 xtures maximum After the maximum xtures

has been reached you will need to use a new power outlet. They

must be the same xtures. DO NOT mix xtures.

Flash Kling Batten Daisy-Chaining Units