FLASH KLING BATTEN ADJ Products, LLC 6122 S. Eastern Ave. Los Angeles, CA 90040 USA Tel: 323-582-2650 / Fax: 323-725-6100 Web: www.adj.com / E-mail: info@americandj.com A.D.J. Supply Europe B.V. Junostraat 2 6468 EW Kerkrade Netherlands service@adjgroup.eu / www.adj.
©2015 ADJ Products, LLC all rights reserved. Information, specifications, diagrams, images, and instructions herein are subject to change without notice. ADJ Products, LLC logo and identifying product names and numbers herein are trademarks of ADJ Products, LLC. Copyright protection claimed includes all forms and matters of copyrightable materials and information now allowed by statutory or judicial law or hereinafter granted.
Flash Kling Batten Notes Flash Kling Batten Introduction Unpacking: Thank you for purchasing the Flash Kling Batten by ADJ Products, LLC. Every Flash Kling Batten has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all accessories necessary to operate the unit has arrived intact.
Flash Kling Batten General Instructions To optimize the performance of this product, please read these operating instructions carefully to familiarize yourself with the basic operations of this unit. These instructions contain important safety information regarding the use and maintenance of this unit. Please keep this manual with the unit, for future reference. Flash Kling Batten Features • CAT 5 Straight Network Cable included.
Flash Kling Batten Fuse Replacement Locate the fuse holder at the end of the base opposite end of the eithernet connection. Using a phillips head screwdriver, remove the fuse holder. Remove the used fuse and replace with a matching fuse. Insert the fuse holder and fuse into the unit and secure the fuse holder. Flash Kling Batten Cleaning Due to fog residue, smoke, and dust cleaning the internal and external optical lenses must be carried out periodically to optimize light output. 1.
Daisy-Chaining Units Do not daisy-chain more than 50 Panels when connecting directly to a computer. To daisy-chain more than 50 Panels you must use a Ethernet Switch. When using a Ethernet Switch, do not daisy-chain more than 50 Panels from a single network port of the Ethernet Switch. A maximum 2 output network ports of the Ethernet Switch can be used. So the system can control 100 Panels maximum, no more. See the directions under the connection diagrams on page 6.
