User manual

ADJ Products, LLC - www.adj.com - WiFly EXR QA5 IP User Manual Page 5
WiFly EXR QA5 IP IP Notice
IP65 RATED
An IP rated lighting fixture is one, which is commonly installed in outdoor
environments and has been designed with an enclosure that effectively
protects the ingress (entry) of external foreign objects such as dust and
water. The International Protection (IP) rating system is commonly expressed
as "IP"
(Ingress Protection) followed by two numbers (i.e. IP65) where the
numbers define the degree of protection. The first digit (Foreign Bodies
Protection) indicates the extent of protection against particles entering the
fixture and the second digit (Water Protection) indicates the extent of
protection against water entering the fixture. An IP65 rated lighting fixture is
one, which has been designed and tested to protect against the ingress of
dust (6) and high-pressure water jets from any direction (5).
MARINE/COASTAL ENVIRONMENT INSTALLATIONS!
Please note although this fixture is IP rated, the fixture is NOT suitable for
marine and/or coastal environment installations. Installing this fixture in a
marine and/or coastal environment may cause corrosion and/or excessive
wear to the interior and/or exterior components of the fixture. Damages
and/or performance i
ssues resulting from installation in a marine and/or
coastal environment will void the manufactures warranty and will NOT be
subject to any warranty claims and/or repairs.
Ensure ALL connections and end caps are properly sealed with a non-
conductive dielectric grease (available at most electrical suppl
iers) to
prevent water ingress/condensation and/or corrosion.
OPTIONAL CORROSION- RESISTANT COATING
Optional Corrosion-Resistant Coatings may be available for this fixture.
Please consult your Elation Professional sales representative for details.
ADJ Products, LLC - www.adj.com - WiFly EXR QA5 IP User Manual Page 30
WiFly EXR QA5 IP Battery Status & Charging
Battery Status:
This function is used to check the life status of the battery.
Plug the fixture in and press the MODE button until “BATT LEV
XXX%” is displayed. “XXX” represents the current battery life.
The number that is displayed is the remaining battery life. If
“BATT LEV ----” is displayed, it means that you are running the
unit on AC power. Please do not let the battery fully die, this
severly shortens the life of the battery.
NOTE: When the battery life is below 30% the battery percent-
age will flash. At 15% power the fixture will shut off.
NOTE: When using battery power, after 20 seconds of inac-
tivity, the display will revert back to the battery life display.
Battery Recharge: To recharge the battery, plug the supplied
AC cord into the AC input on the side of the unit and plug the
other end into a matching power supply. It takes about 5 hours
to reach full charge (with the power o). The display will STOP
ashing when the unit reaches 100% charge.
Note: When unplugging the unit from charging and then
applying power via battery, there will be a minimal charge
drop.
For a faster recharge, turn the Load setting to “O” and turn the
battery “On”. See Battery Load on page 15.