User manual

ADJ Products, LLC - www.adj.com - WiFly EXR Dotz Par User Manual Page 11
ADJ Products, LLC - www.adj.com - WiFly EXR Dotz Par User Manual Page 10
appear under the rst letter of the current displayed dimmer
curve.
3. Use the UP or DOWN buttons to change the dimmer curve
setting.
4. Once you have found your desired dimming curve, press the
ENTER button again.
Built-In Programs - Select 1 of 4 programs. RGB
Dimmer Mode, 7 Color Change, 3 Color Change 3, or Color
Fade.
1. Press the MODE button until either “1. MANUAL”, “2. CHANGE”,
“3. CHANG3”, or “4. FADE” is displayed.
2. Press the ENTER button and a ashing underscore will appear
under the rst number. Use the UP and DOWN buttons to scroll
through the 4 dierent programs. Note: For “1. Manual” instruc-
tions see RGB Dimmer Mode.
3. Both Color Change programs and the Color Fade program
have adjustable changing and fading speeds. Once you have
found your desired program, press ENTER.
4. The ashing underscore will now appear under the program
speed adjustment. Use the UP and DOWN buttons to adjust the
program speed. Press ENTER once you nd your desired speed.
5. The ashing underscore will now appear under the strobe
speed adjustment. Use the UP and DOWN buttons to adjust the
strobe speed or completely turn it o. The “00” setting turns the
strobe o, “01” is the slowest strobe rate, and “99” is the fast-
est strobe rate. Press ENTER once you nd your desired strobe
setting.
WiFly EXR Dotz Par System Menu
Control Panel Lock:
The control panel will lock itself after 30 seconds if nothing is
pressed. To unlock the control panel, press the MODE button for
3 seconds.
DMX Mode - Setting the DMX Address -
1. Press the MODE button until “DMX MODE ADDR: XXX” is dis-
played. “XXX” represents the current displayed address. Press
the ENTER button.
2. After pressing the ENTER button a ashing underscore should
appear under the last number. Use the UP or DOWN buttons to
change the DMX address.
3. Once you have found your desired DMX address, press the
ENTER button again.
DMX Channel Mode - This function will allow you to
set your desired DMX channel mode -
1. Press the MODE button until “CHANNEL CH: XXX” is dis-
played. “XXX” represents the current displayed DMX channel
mode. Press the ENTER button.
2. After pressing the ENTER button a ashing underscore should
appear. Use the UP or DOWN buttons to change the DMX chan-
nel mode.
3. Once you have found your desired DMX channel mode, press
the ENTER button again.
Dimmer Curve - This setting will let you select your
desired dimmer curve. See the dimmer curve chart on page
23.
1. Press the MODE button until “DimCurve” is displayed. Under-
neath “DimCurve” is the current dimming curve setting.
2. Press the ENTER button and a ashing underscore should
WiFly EXR Dotz Par System Menu