User manual

Mode Button Lock:
The MODE button will lock itself after 30 seconds if nothing is
pressed. To unlock the unit, press the MODE button for 3 sec-
onds.
Mode Operation:
Each press of the MODE button will cycle through the different oper-
ating modes. The operating modes are listed below in the order that
they appear.
NOTE: When power is turned OFF and turned back ON, the unit
will start in the last operating mode.
Order of Operating Modes:
• 100% Brightness • 95% Brightness • 90% Brightness
• 84% Brightness • 78% Brightness • 72% Brightness
• 66% Brightness • 60% Brightness • 54% Brightness
• 48% Brightness • 42% Brightness • 36% Brightness
• 30% Brightness • 24% Brightness • 18% Brightness
• 12% Brightness • 6% Brightness • LED Off • Fast Fade • Slow
Fade
Pressing the MODE button again after Slow Fade will return the unit
to 100% brightness. Starting the operating mode order at the begin-
ning.
PinPoint Gobo Operating Instructions
ADJ Products, LLC - www.adj.com - PinPoint Gobo User Manual Page 8
Full On Mode, 3.3W Mode, & Energy Saving Mode:
The Pinpoint Gobo has 3 LED modes; full on mode, 3.3W mode, and
energy saving mode. When the PinPoint Gobo is set into energy sav-
ing mode, it will decrease the LED brightness gradually when the bat-
tery life is less than 80% to extend the battery life.
NOTE: When the unit is using DC power, the energy saving mode
cannot be used.
1. Press the MODE button for 5 seconds to switch between normal
mode, 3.3W mode and energy saving mode. When the LED flashes
two times, the PinPoint Gobo is in full on mode. When the LED flash-
es 5 times the PinPoint Gobo is in 3.3W mode. When the LED flashes
10 times the PinPoint Gobo is in energy saving mode.
2. When using the ADJ LED RC3, press the BLACKOUT button for 5
seconds. When the LED flashes two times, the PinPoint Gobo is in full
on mode. When the LED flashes 5 times the PinPoint Gobo is in 3.3W
mode. When the LED flashes 10 times the PinPoint Gobo is in energy
saving mode.
3. When using the UC IR, press the STAND BY button for 5 seconds.
When the LED flashes two times, the PinPoint Gobo is in full on
mode. When the LED flashes 5 times the PinPoint Gobo is in 3.3W
mode. When the LED flashes 10 times the PinPoint Gobo is in energy
saving mode.
Low Battery Warning:
When the battery power gets below 30%, the LED will flash rapidly for
5 seconds each time the power is switched ON. After the 5 seconds,
the unit will function normally. This is a warning letting you know that
you must charge the unit soon.
Operating Power:
There are two ways to supply power to this unit; battery power or DC
power.
• DC Power - To run the unit using DC power, plug the unit into a DC
power source, and put the POWER switch into the ON position.
• Battery Power - To run the unit using Battery power, put the POWER
switch in the ON position.
PinPoint Gobo Operating Instructions
ADJ Products, LLC - www.adj.com - PinPoint Gobo User Manual Page 7