User manual
ADJ Products, LLC - www.adj.com - PinPoint Gobo User Manual Page 6
2.5 Do Not Expose the Battery to water or liquids
Never soak/drop the batteries in liquids such as water, seawater,
drinks such as soft drinks, juices, coee or other.
2.6 Battery Replacement
For battery replacement please contact ADJ customer support (800)
322-6337.
2.7 Do Not use a damaged Battery
The battery could be damaged during shipping, caused by shock.
Should the battery be found damaged, including damages to the
plastic casing of the battery, deformation of the battery package,
smelling of an electrolyte, or leakage of the electrolyte gel, or other,
DO NOT use the battery. A battery with a odor of electrolyte or a gel
leakage should be placed away from re to avoid re or explosion.
3. Battery Storage
When storing the battery, it should be stored at room temperature,
with a charge of at least 50%. We recommend that during long peri-
ods of storage that the battery be charged every 6 months. Doing
this will prolong the life of the battery and will also make sure that the
battery charge does not fall below the 30% mark.
4. Other Chemical Reaction
Because batteries utilize a chemical reaction, battery performance
will deteriorate over time even if stored for a long period of time
without being used. In addition, if the various usage conditions such
as charge, discharge, ambient temperature, etc. are not maintained
within the specied ranges, the life expectancy of the battery maybe
shortened or the device in which the battery is used may be damaged
by electrolyte gel leakage. If the batteries cannot maintain a charge
for long periods of time, even when they are charged correctly, this
may indicate it is time to change the battery.
5. Battery Disposal
Please dispose of battery according to local regulations.
PinPoint Gobo Battery Precautions
The PinPoint Gobo comes with 4 color filters and a frost filter. To install
any of the filters remove gobo holder from the fixture. Remove the
retainer ring that holds the gobo in place. Install the filter and replace
the retainer ring.
The unit has two ways that it can be installed. The unit includes
a X-Clip so that it can be installed on drop down ceilings. Always
ensure that the unit is rmly xed to avoid vibration and slipping while
operating. Always ensure that the structure to which you are attach-
ing the unit is secure and is able to support a weight of 10 times the
unit’s weight. Always use a safety cable that can hold 12 times the
weight of the unit when doing this type of installation. The safety
cable should go through the eye hole nut that holds the X-Clip base in
place.
You can also install using the magantic base. To do this, remove the
X-Clip base by unscrewing the eye hole bolt. Once removed the x-
ture can be stuck to anything magnetic.
The equipment must be installed by a professional, and it must
be installed in a place where it is out of the reach of people’s
grasp.
PinPoint Gobo Color Filter Install
PinPoint Gobo Installation
ADJ Products, LLC - www.adj.com - PinPoint Gobo User Manual Page 9
The PinPoint Gobo comes with 4 replaceable gobos (see below).
To install a gobo, remove the gobo holder by unscrewing the thumb
screw that is securing the gobo holder located at the top of the fixture.
Remove the retainer ring that holds the gobo in place. Install the gobo
and replace the retainer ring.
PinPoint Gobo Gobo Install