User manual

PinPoint Gobo Safety Precautions
ADJ Products, LLC - www.adj.com - PinPoint Gobo User Manual Page 4
• To reduce the risk of electrical shock or re, do not expose this unit
rain or moisture
• Do not spill water or other liquids into or on to your unit.
• Be sure that the local power outlet match that of the required volt-
age for your unit.
• Do not attempt to operate this unit if the power cord has been
frayed or broken. Do not attempt to remove or break o the ground
prong from the electrical cord. This prong is used to reduce the risk
of electrical shock and re in case of an internal short.
• Disconnect from main power before making any type of connection.
• Do not remove the cover under any conditions. There are no user
serviceable parts inside.
• Never operate this unit when it’s cover is removed.
• Never plug this unit in to a dimmer pack
• Always be sure to mount this unit in an area that will allow proper
ventilation. Allow about 6” (15cm) between this device and a wall.
• Do not attempt to operate this unit, if it becomes damaged.
• This unit is intended for indoor use only, use of this product out`
doors voids all warranties.
• During long periods of non-use, disconnect the unit’s main power.
• Always mount this unit in safe and stable matter.
• Power-supply cords should be routed so that they are not likely to
be walked on or pinched by items placed upon or against them,
paying particular attention to the point they exit from the unit.
• Cleaning -The fixture should be cleaned only as recommended by
t he manufacturer. See page 12 for cleaning details.
• Heat -The appliance should be situated away from heat sources
such as radiators, heat registers, stoves, or other appliances (inclu-
d ing amplifiers) that produce heat.
• The fixture should be serviced by qualified service personnel when:
A. The power-supply cord or the plug has been damaged.
B. Objects have fallen, or liquid has been spilled into the appliance.
C. The appliance has been exposed to rain or water.
D. The appliance does not appear to operate normally or exhibits a
marked change in performance.
PinPoint Gobo ADJ LED RC3 Remote
The ADJ LED RC3 infrared remote (Sold Separately) has many dif-
fernet functions and gives you complete control of your PinPoint
Gobo. To control the your desired fixture you must aim the controller
at the front of the fixture and be no more the 30 feet away.
BLACKOUT - Pressing this button will blackout the fixture. This but-
ton is also used to switch between full on mode, 3.3W mode, and en-
ergy saving mode. To switch between the modes see page 7.
AUTO RUN - Press this button to switch between fast fade and slow
fade. Press the Speed button and use the “+” & “-” buttons to adjust
the program speed. Press the Flash button to activate strobing and
use the “+” & “-” buttons to adjust the strobe speed.
STATIC COLOR MODE - Press the “SELECT PROG” button to ac-
tivate color mode. Use the “+” & “-” buttons to adjust the intensity.
Press the Flash button to activate strobing and use the +” & “-” but-
tons to adjust the strobe speed.
ADJ Products, LLC - www.adj.com - PinPoint Gobo User Manual Page 11