PinPoint Gobo ADJ Products, LLC 6122 S. Eastern Ave. Los Angeles, CA 90040 USA Tel: 323-582-2650 / Fax: 323-725-6100 Web: www.adj.com / E-mail: info@americandj.com A.D.J. Supply Europe B.V. Junostraat 2 6468 EW Kerkrade The Netherlands service@adjgroup.eu / www.adj.
©2016 ADJ Products, LLC all rights reserved. Information, specifications, diagrams, images, and instructions herein are subject to change without notice. ADJ Products, LLC logo and identifying product names and numbers herein are trademarks of ADJ Products, LLC. Copyright protection claimed includes all forms and matters of copyrightable materials and information now allowed by statutory or judicial law or hereinafter granted.
PinPoint Gobo Warranty MANUFACTURER’S LIMITED WARRANTY A. ADJ Products, LLC hereby warrants, to the original purchaser, ADJ Products, LLC products to be free of manufacturing defects in material and workmanship for a prescribed period from the date of purchase (see specific warranty period on reverse). This warranty shall be valid only if the product is purchased within the United States of America, including possessions and territories.
PinPoint Gobo General Instructions PinPoint Gobo Photometric Chart PinPoint Gobo Cleaning To optimize the performance of this product, please read these operating instructions carefully to familiarize yourself with the basic operations of this unit. These instructions contain important safety information regarding the use and maintenance of this unit. Please keep this manual with the unit, for future reference.
PinPoint Gobo ADJ LED RC3 Remote The ADJ LED RC3 infrared remote (Sold Separately) has many differnet functions and gives you complete control of your PinPoint Gobo. To control the your desired fixture you must aim the controller at the front of the fixture and be no more the 30 feet away. BLACKOUT - Pressing this button will blackout the fixture. This button is also used to switch between full on mode, 3.3W mode, and energy saving mode. To switch between the modes see page 7.
PinPoint Gobo Battery Precautions 1. Handling of Batteries 1.1 Do Not Short Circuit the Battery Try to never short circuit the battery. It generates a very high current which could cause the battery to overheat which may result in electrolyte gel leakage, harmful fumes, or explosion. The LIR tabs may easily short-circuit by placing them on conductive surface. A short circuit may lead to heat build up and damage of the battery.
PinPoint Gobo Gobo Install The PinPoint Gobo comes with 4 replaceable gobos (see below). To install a gobo, remove the gobo holder by unscrewing the thumb screw that is securing the gobo holder located at the top of the fixture. Remove the retainer ring that holds the gobo in place. Install the gobo and replace the retainer ring. PinPoint Gobo Color Filter Install The PinPoint Gobo comes with 4 color filters and a frost filter. To install any of the filters remove gobo holder from the fixture.
PinPoint Gobo Operating Instructions Full On Mode, 3.3W Mode, & Energy Saving Mode: The Pinpoint Gobo has 3 LED modes; full on mode, 3.3W mode, and energy saving mode. When the PinPoint Gobo is set into energy saving mode, it will decrease the LED brightness gradually when the battery life is less than 80% to extend the battery life. NOTE: When the unit is using DC power, the energy saving mode cannot be used. 1. Press the MODE button for 5 seconds to switch between normal mode, 3.
