User Manual
©American Audio® - www.americanaudio.us - VMS5.0 Instruction Manual Page 12
FRONT PANEL -
Turns the corresponding microphone on/off. When you Mic is on the button will
be backlit by a red LED.
24. MIC GAIN CONTROL - Increase or decrease the microphone output.
25. MIC EQ - Adjust the treble, mid, and bass on the corresponding Mic inputs.
These will switch the corresponding Channel from USB audio stream
or analog audio input. USB will route the software assigned ASIO audio channel thru the corre-
sponding MIDILOG channel. Analog will route the analog audio input from the rear panel thru the
corresponding MIDILOG channel.
CF Assign A will select the desired channel to the left side of the crossfad-
er.* CF Assign B will select the desired channel to the right side of the crossfader.*
* Normal Mode: This will be the opposite when the crossfader is reversed.
* The CROSSFADER will only effect a channel's volume when the channel is assigned.
-
Sets MIDILOG channels 2 & 3 to receive audio from software with
ASIO outputs and sends audio or control tones from the channel 2 & 3 RCA inputs to your software
ASIO inputs.
Sets 4 MIDILOG channels to receive audio from software with
ASIO outputs and sends the audio from the master output via USB for recording.
Switches the crossfader from normal to reverse mode. In reverse mode
the CF A assignments will be on the right of the crossfader and the CF B on the left.
This knob will adjust the curve of the crossfader from mix curve, dipped curve,
to scratch curve.
FRONT PANEL - GENERAL FUNCTIONS AND CONTROLS
23 24 25 26
27
26
28
26
26 29 31
27
32 33
30