Installation Manual

8
BUILDING A PROFILE
Editing Presets
Once a channel has been added, it will appear on the left. Dragging the slider will change the value of
the channel. Be sure that the “Start Channel” (that is displayed at the bottom) is the same number as
the DMX address that the actual xture is set to.
Associated presets are displayed on the right. On iPad, these are displayed in a grid view and on
android, these are displayed in a list. To set the start and end value for a preset, tap the preset and then
move the two points on the slider. Notice that when selecting a preset, the DMX value of the channel
will update. This allows you to compare your changes with the actual output of your xture and ensure
that they are correct. Dragging downwards from the slider rst, and then left or right, decreases the
sensitivity, allowing for precise values to be chosen.
For more options, such as Name, Default Preset and Default Value, tap the Preset Properties button.
If the channel has an associated Micro channel, such as µPan and µTilt, tap the “Add Micro” button.
Additional presets can be added or removed by tapping the buttons to the bottom right of the screen.
Presets can be rearranged by touching, holding, and dragging.
Some xtures have more than one operating mode. Several modes can be created by tapping the ‘+’
button at the top of the channel list on the left.