Instructions / Assembly

12
INSTALLATION INSTRUCTIONS
14
Mounting the locker unit(s) to the wall
Double Locker
Ɣ There are two holes near the top of the back panel of your
locker.
Ɣ Place your locker where you want to install it. Using a pencil,
mark the location of each of these holes on the wall.
Ɣ Remove the locker(s) from the wall. In the marked locations,
drill a hole large enough for the anchor screw (make sure you
don’t drill it too large!)
Ɣ Using a Phillips screwdriver, twist each mounting screw
through the back of the locker and into the holes in the wall.
Hand tightening is recommended; using a drill could damage
the hole.
Installation Instructions
Mounting Locker Units
A. There are two holes near the top of the Back Panel (D) of your locker.
B. Place your locker where you want to install it. Using a pencil, mark the
location of each of these holes on the wall.
C. Remove the locker(s) from the wall. In the marked locations, drill a
hole large enough for the Wall Anchors (6) (Make sure you don’t
drill it too large!)
D. Using a Phillips screwdriver, twist each of the Wall Anchors (6)
through the back of the locker and into the holes in the wall. Hand
tightening is recommended; using a drill could damage the hole.
D
6
6