Instructions / Assembly

10
Notes
INSTALLATION INSTRUCTIONS
14
Mounting the locker unit(s) to the wall
Single Locker
Ɣ There are two holes near the top of the back panel of your
locker.
Ɣ Place your locker where you want to install it. Using a pencil,
mark the location of each of these holes on the wall.
Ɣ Remove the locker(s) from the wall. In the marked locations,
drill a hole large enough for the anchor screw (make sure you
don’t drill it too large!)
Ɣ Using a Phillips screwdriver, twist each mounting screw
through the back of the locker and into the holes in the wall.
Hand tightening is recommended; using a drill could damage
the hole.