Instruction manual

26
10 GB Communication
Version
1.0
3
& Control Card Instruction Manual
4.8 LED Connector
The status LEDs port (connector I) is a 10-pin output port on the board
and it can be used to directly drive the LEDs on the front panel of the device
(serial resistors required). POWER ON is high after power up. ERROR is high
if the Hardware Error register is not zero. The OVERLOAD output is driven by
the OVERLOAD input of the CONTROL connector.
Pin
Description
Direction
1
GND
-
2
POWER
ON
Output
3
ERROR
Output
4
STREAMING
Output
5
EXT. CLOCK VALID
Output
6
PDI COMMUNICATION
Output
7
OVERLOAD
Output
8
CAM TIMER ARMED
Output
9
CAM TIMER TRIGGER OUT
Output
10
GND
-
Connector type: Samtec SHF-105-01-L-D-TH
(Cable strip: Samtec FFSD-05-01-N)