User Manual
Table Of Contents
- 一、Overview
- 二、Thanks and Commitment
- 三、What is 3D Printer?
- 四、Printing
- 4.1ADIMLab-gantryArchitecture:
- 4.2Assembly and wiring
- (Please reference SD card file contents“2.Assembly and debugging tutorial”“HCmaker7Assembly instruction”1~2)
- 4.3 First time test the maker7
- (Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”3)
- 4.3.1 Home test:
- 4.3.2Heating test:
- 4.4First time prepare printing:
- (Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”4)
- 4.4.1XaxisHeight calibration:
- 4.4.2Leveling Heating Platform:
- 4.4.3 First time test the maker7:
- (Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”5)
- (1)“Info screen” Press the knob,Rotate select“Print from SD”,Click OK:
- 五、Slice software installation and configuration
- 9 Support and service

48
(3)Setting nozzle or hotbed temperature,click ok
7.7 Adjust printing speed:
(1)“Info screen” rotate the knob,adjust speed:
8,Problem Solutions
8.1 Analysis common problem:
(Please reference SD card file“9.Analysis common problem FAQ”
“Common problem solutions”)
8.2 Protect heating:
(Please reference SD card file“9.Analysis common problem”“ Protect
heating”)