User Manual
Table Of Contents
- 一、Overview
- 二、Thanks and Commitment
- 三、What is 3D Printer?
- 四、Printing
- 4.1ADIMLab-gantryArchitecture：
- 4.2Assembly and wiring
- （Please reference SD card file contents“2.Assembly and debugging tutorial”“HCmaker7Assembly instruction”1~2）
- 4.3 First time test the maker7
- （Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”3）
- 4.3.1 Home test：
- 4.3.2Heating test：
- 4.4First time prepare printing:
- （Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”4）
- 4.4.1XaxisHeight calibration：
- 4.4.2Leveling Heating Platform：
- 4.4.3 First time test the maker7：
- （Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”5）
- (1)“Info screen” Press the knob，Rotate select“Print from SD”,Click OK：
- 五、Slice software installation and configuration
- 9 Support and service
4
一、Overview
Thank you for your support of our company's products,the guidelines
only apply to ADIMLab-gantry 3D printer. This guide is based on Win7
operating system.
Chapter 1: Introduction of architecture, settings, and other preparatory
work
Chapter 2: Introduction of software and printing step
Chapter 3: Introduction of actual printing operation and the print methods
Chapter 4: Technical support and guidance
Please read carefully before using the printer ADIMLab-gantry
as following:
* Before you run the printer, please ensure its grounded to protect the
printer from electrostatic interference.
* When doing maintenance for the printer, please turn off the power and
unplug the power cord.
* Do not leave the printer running in the absence of probation conditions.
* Do not touch the nozzle under heating , and above 60 ℃
printplatform.
* Some printing supplies at high temperatures melt will produce a slight
odor, pleaseuse the printer in a well-ventilated conditions.
* First adjust the machine before printing platform parallel with the print
nozzles to prevent nozzle rub internet.