User Manual

2
Contents
一、 Overview ............................................................................................. 4
二、Thanks and Commitment .................................................................. 6
三、What is 3D Printer ............................................................................... 7
3.1 3D printing steps ................................................................................ 7
3.2 3D Modeling ...................................................................................... 7
3.3 Slice output 3D model ........................................................................ 8
四、Prepare printing ................................................................................... 9
4.1 ADIMLab-gantry printer architecture .............................................. 10
4.2Assembly and wiring ........................................................................ 11
4.3 First time test the ADIMLab .......................................................... 11
4.4 First time prepare printing ................................................................ 13
五、Slice software installation and configuration ................................... 17
5.1 Software copy .................................................................................. 17
5.2 Install software ............................................................................ 17
5.3 Setting software ............................................................................... 23
5.4 Slicing software setting .................................. 错误！未定义书签。7
六、Start printing ...................................................................................... 30
6.1 Select printing model ....................................................................... 31
6.2Model slice ........................................................................................ 32
6.3Install filament .................................................................................. 33