User Manual
Table Of Contents
- 一、Overview
- 二、Thanks and Commitment
- 三、What is 3D Printer?
- 四、Printing
- 4.1ADIMLab-gantryArchitecture：
- 4.2Assembly and wiring
- （Please reference SD card file contents“2.Assembly and debugging tutorial”“HCmaker7Assembly instruction”1~2）
- 4.3 First time test the maker7
- （Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”3）
- 4.3.1 Home test：
- 4.3.2Heating test：
- 4.4First time prepare printing:
- （Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”4）
- 4.4.1XaxisHeight calibration：
- 4.4.2Leveling Heating Platform：
- 4.4.3 First time test the maker7：
- （Please reference SD card file contents“2.Assembly and debugging”“HCmaker7Assembly instruction”5）
- (1)“Info screen” Press the knob，Rotate select“Print from SD”,Click OK：
- 五、Slice software installation and configuration
- 9 Support and service
14
test shaft guide distance between the two ends and the base,
Make the metal parts at both ends of the X-axis guide just touch
the glue stick or print model.
4.4.2Leveling Heating Platform：
(1) “Info screen” Press the knob，Rotate select“Prepare”,Click
OK：
(2) Select“Manual Bed Leveling”in Submenu，Click OK：
(3) First printer will Perform homing，Then extruder moves
to the first adjustment point in the lower left corner of the
hot bed.