Application Guide

Skype and Q&A Face book group: ADIMLab 3D Printer
Contact: [e-mail] Skype: ADIMLab 3D Printer facebook group: ADIMLab 3D Printer
②If you could find the filament comes out, it proves you load the
filament well, and there is no clog in the hot end system：
Common problem during this statement:
① When load the filament, did not press the Press down the extruder
plunger：will result the Extruder gear didn’t rotate and lead the
filament to the nozzle，and cannot extrude during printing。
② If not insert filament and push it to the end, also will result the
extrude problem, and cannot extrude during printing.