Application Guide

Skype and Q&A Face book group: ADIMLab 3D Printer
Contact: [e-mail] Skype: ADIMLab 3D Printer facebook group: ADIMLab 3D Printer
d. if still can’t clean the nozzle well, please refer to:
https://www.facebook.com/groups/1235236596606278/permalink/130218123
3245147/?__xts__[0]=68.ARAOFv3Zb4TNINGjZuoJR8_-DakZrLYlP4XVUFS
74agujt2Lq0RjZD4ubmRaYFK6aOKgGGjBoKXqPJ7HXvHEMjAn9LeX-xDu
WsJpOVjAZG3-VuIyfvbG4rj8VqyjE7tVHsNLG5HsZhkgM503M9jmLWqzuTx1
fcnb3gt5x5CZkQ5pepyh5aZh&__tn__=-UC-R
④ The extruder motor swings back and forth, resulting in no extruding：
Solution：if the extruder wire One phase has poor electrical contact or
disconnection, will result the motor swings, you can find this problem via
seeing the extruder gear. You need to check the plugs and pins are in good
condition.