Application Guide

Skype and Q&A Face book group: ADIMLab 3D Printer
Contact: [e-mail] Skype: ADIMLab 3D Printer facebook group: ADIMLab 3D Printer
solution：Check if the filaments are smooth and rearranged.
② The extruder fan not rotate, the throat heat up and result in the clog of
the Teflon tube inside the throat, the extruder will makes a "squeaky"
sound.
solution：check if the extruder fan is working. Please make sure it’s always
on.
③ If you press down the extruder plunger and manually insert the
filament to the nozzle, there is no filament get out, prove Hot end
system get clogged, and the extruder will makes a "squeaky" sound.
solution：
a. Stop the printing first, keep the nozzle temp at 200℃.
b. Press down the extruder plunger, use hand or tweezers to pull the
filament out of the hot end system.Notice, please keep the process being
slowly.
c. Push the new filament, make sure the front of the filament is straight,
into the hot end manually, if there is filament get out, you solved the
problem.
d. If still no filament get out, please keep the 200℃, and pull the filament
out, press the extruder plunger down, use the follow tool to Insert the
inside of the nozzle from the inlet of the extruder and squeeze it hard.