Application Guide

Skype and Q&A Face book group: ADIMLab 3D Printer
Contact: [e-mail] Skype: ADIMLab 3D Printer facebook group: ADIMLab 3D Printer
Please refer to this article to get more problem solution:
https://www.prusaprinters.org/how-to-fix-the-most-common-3d-printing-errors/
6.How to solve the problem of the extruder not working：
（1）didn’t push the filament to the bottom：
phenomenon：The extruder gear is rotating, but there is no filament get out.
solution：Insert filament and push it to the end, the insert length is about
90mm.
（2）Nozzle scraping to hot bed：
phenomenon：The extruder emits a "click" sound, and the extruder cannot
extrude out.
solution：please level the bed again, make sure the distance between the
nozzle and the bed is about one thin paper thick.
（3）can’t get out the filament during printing：
① the filament are entangled，result in the shortage of filament feeding,
and no filament out of the nozzle. And the extruder gear will also make
a "squeaky" sound due to the "planing"。