Application Guide

Skype and Q&A Face book group: ADIMLab 3D Printer
Contact: [e-mail] Skype: ADIMLab 3D Printer facebook group: ADIMLab 3D Printer
（10）the Extruder come back to the previous printing position，continue
printing：
5.Test printing：
（Please refer to the instruction in the SD card: “ ADIMLab Assembly
specifications ”the 4
th
and 5
th
chapters in the directory of“ 2.Assembly
specifications ”）
（1） Common problems：
① The first layer does not stick to the print surface
This is by far the most common 3D printing problem, and probably the first one you may
encounter. The first layer is the essential one as it is the base of the printed object.
Therefore, if it isn’t perfect, the chance of print failure increases.
What happens when the first layer isn’t perfect? Most of the time you will not be able to
start the printing process, or the printed objects may continue to constantly detach from
the print surface.
Making the first layer stick:
 Proper calibration of the first layer – First, you must perform the First layer calibration.
Once you are happy with the result, you can start printing. Later on, you may apply
small adjustments to the nozzle height through the Live Adjust Z option when the
printer is creating the initial three layers. Just press the Knob and go to the Live Adjust
Z. If you are not sure how the proper first layer looks, check out the photo above.