Specifications

7-4 Error Messages
600561-A
03 Type 3 Software errors including Microcode and Operating System errors.
Retrieve the current Microcode dump.
Force another Microcode Dump and retrieve it.
Power Off and On the Scalar 1000 Control Module to recover from the error.
Use the Circuit Breaker to perform this action. Wait at least one minute between
Power Off and Power On.
If the problem is not corrected or persists, contact ATAC.
04 Type 4 Software errors including Microcode and Operating System errors
(the errors are not mapped).
Retrieve the current Microcode dump.
Force another Microcode Dump and retrieve it.
Power Off and On the Scalar 1000 Control Module to recover from the error.
Use the Circuit Breaker to perform this action. Wait at least one minute between
Power Off and Power On.
If the problem is not corrected or persists, contact ATAC.
05 A permanent Software error occurred
Power Off and On the Scalar 1000 Control Module to recover from the error.
Use the Circuit Breaker to perform this action. Wait at least one minute between
Power Off and Power On.
If the problem is not corrected or persists, contact ATAC.
10 Barcode scanner communications failed.
Power Off and On the Scalar 1000 Control Module to recover from the error.
Use the Circuit Breaker to perform this action. Wait at least one minute between
Power Off and Power On.
If the problem is not corrected or persists, contact ATAC.
12 Barcode scanner communication is OK, Barcode scanner reports that data is
bad.
Retrieve the current Microcode dump.
If the problem is not corrected or persists, contact ATAC.
Table 7-1
SAC Reporting
Reported
SAC
Perform these actions