Specifications

30 MX1 Single Channel MPEG 2 Decoder Operation Manual
Mode <MCD Plus>
Add Service
Remove Service
Reset Slot
Figure 67: Full MCD Slot Menu
2. To edit the Mode parameter, press
►
to move the cursor to the right side of the
LCD screen and press ▼ and ▲ to select either MCD Plus or MCD Pro.
To add a service, select Add Service. The Add Service Menu screen appears with a
list of available services. Choose the service you wish to add and press ENTER.
To remove a service, select Remove Service. The Remove Service Menu screen
appears with a list of available services. Choose the service you wish to delete and
press ENTER.
To reset the slot, select Reset Slot.
3. Press ENTER to save your changes and return to the CA System Menu.
Press ESC to discard your changes and return to the CA System Menu.
To configure the BISS parameters:
1. From the Main Menu, select CA System > BISS. The BISS Menu screen appears.
Figure 69: BISS Menu Screen
2. Select the desired parameter and press
►
to move the cursor to the right side of
the LCD screen.
3. Press
▼
and
▲
to change the parameter to ON or OFF.
4. Press ENTER to save your changes and return to the CA System Menu.
Press ESC to discard your changes and return to the CA System Menu.
Parameters:
• BISS 1 -> Set SW <************> Press ▼ and ▲ to change 12 digits.
• BISS E -> BISS MODE:
o Injected ID -> ESW <****************> Press
▼
and
▲
to change
16 digits, and ID <**************> Press ▼ and ▲ to change 14
digits.
o Buried ID -> ESW <****************> Press ▼ and ▲ to change 16
digits.