Specifications

MX1 Single Channel MPEG 2 Decoder Operation Manual 25

Press ENTER to save your changes and return to the left side of the menu.
Press ESC or ◄ to discard your changes and return to the left side of the menu.
 To configure additional parameters, repeat steps 2 - .

Press
►
or ENTER to save changes and return to the Output Menu.
Press ESC to discard your changes and return to the Output Menu.
Configuring the IP Out
1. Select OUTPUT.
2. Press ► over IP OUT.
3. Use ▼ and ▲ buttons to change the input or to set it on off.
4. Press ENTER.
5. Change the destination IP address:
IP <225.20.20.20>
6. Define the port number:
PORT NUMBER <11111>
7. choose the Mode:
(no change, service filter, Block all, Bypass all)
Mode <
Service filter
>
Bit Rate { 18 M }
8. If Service filter chosen, press ENTER to select/deselect a service.
Configuring the Low Speed Data (RS-232)
To configure the low speed data (RS-232):
1. From the Main Menu, select Output. The Output Menu screen appears (Figure 47).
2. Press
▼
to scroll down to LSData (RS-232).
3. Press
►
to configure the low speed data (RS-232). The LSData Menu screen
appears.