Specifications

4 MX1 Single Channel MPEG 2 Decoder Operation Manual
The rear panel contains the power connector, power switch, and communications
connectors for the MX1 hardware configuration, which may vary according to
configuration.
Figure 4: Rear Panel
XLR Cable Wiring
Figure 5: Rear Panel 9-Pin D-Type to XLR Connector
If you connect a computer to MX1 Serial Port 1 or 2, you must configure the computer
port to the settings listed in Table 2.
Table 2: Serial Line Connection Requirements
Serial Line Parameter Required Setting for Connected Computer
Baud Rate 115200
Parity None
Data Bits 8