User guide

RF45

User Guide

Ref. 09-08-V0-smn p 23

Default menu

This “default” item of the menu resets some parts of “channel 1”

configuration, “channel 2” configuration, “email” settings, “expert” and

“security” settings to the factory default settings.

The settings for IP address, gateway IP address, netmask, network mode,

topology and wireless security settings remain unchanged.

The specific settings modified by the “default” option are listed below.

Server configuration

All parameters Not changed

Channel 1 configuration

Baudrate 9600

I/F mode 4C (1 stop bit, no parity, 8 bit, RS232, no flow

control)

Port No 10001

Connect mode C0 (always accept incoming connection; no

active connection startup)

Send +++ in modem mode Y

Show IP address after ‘RING’ Y

Auto increment source port N

All other parameters 0

WLAN configuration

Topology Ad-Hoc

Network name Not changed

Channel Not changed

Security Not changed

Authentication Not changed

TX Data rate 1 (auto fallback)

TX Data rate Not changed

Enable power management N (No)

Enable Soft AP Roaming Not changed