User guide

A
RF45-PRO
User Guide
Ref. 11-06-V0-ffr
p 51
All of these commands behave like a modem. For commands that are valid
but not applicable to the ARF45-PRO, an “OK” message is sent (but the
command is silently ignored).
The ARF45-PRO attempts to make a Command Mode connection as per the
IP/DNS/port numbers defined in Connect Mode. It is possible to override the
remote address, as well as the remote port number.
When using ATD, enter 0.0.0.0 to switch to Command Mode.
Entering Command mode on the ARF45-PRO
Like mentioned previously in this document, the modem emulation mode can
be used to enter the command mode at any time. In order for this to work,
both the Accept and Connect mode has to be set with the Modem emulation
mode. Then entering the “+++” string enables to switch to command mode
at any time without resetting the device.
For the Accept tunnel connection, the connection can be established
automatically (initiated from a remote node on the network) if configured.
However for the Connect tunnel connection, the ATD command has to be
entered in order to establish the connection with the remote node on the
network.