User guide

A
RF45-PRO
User Guide
Ref. 11-06-V0-ffr
p 22
Command mode configuration
As an alternative to using the Web Manager, you can configure the ARF45-
PRO through the command line interface (CLI) using a series of commands.
The command mode interface can be accessed through a Telnet session or a
direct connection to a serial port.
Configuration using Telnet session
To configure the ARF45-PRO device using a Telnet session over the network,
establish a Telnet connection:
1. From the Windows Start menu, click Run. The Run dialog box
appears.
2. In the Run dialog box, type the following command, where x.x.x.x
is the IP address of the ARF45-PRO device: telnet x.x.x.x
=> The command mode prompt shows up.
Figure 8