User guide

A
RF45-PRO
User Guide
Ref. 11-06-V0-ffr
p 14
PRO can be configured over the network through an AP (Infrastructure) or a
Wireless Network Card (Ad-Hoc). The prerequisite for this is to apply the
ARF45-PRO’s default WLAN settings to the AP or the Wireless Card. On top of
this, a DHCP server must be present in the network in order to be able to
proceed to the very first configuration of the product over the network!!
The ARF45-PRO also gives the possibility to create new WLAN profiles.
For instance, the figures below (figure 2 to figure 5) show the four active
WLAN profiles contained in an ARF45-PRO device: the two default profile
(which have been kept) and two WLAN profiles which have been created for
different purpose.
Important Point
:
The ARF45-PRO can be used to connect to another ARF45-PRO in Ad-Hoc
mode (for instance in order to establish a direct network connection between
2 ARF45-PRO).
If such a topology is to be used, the user must make sure that the
AdHoc
merging
setting is enabled (if not, trouble during the connection may
occur)!!!