User's Manual

SIGFOX US demonstrator – User guide v1.1
page : 11 / 16
ATS302
Set/Get Ouput Power in dBm.
Parameter is Read-only in the demonstrator
Cmd: ATS302?
Resp: 22
AT$IF
Carrier Frequency Macro Channel Configuration
Cmd: AT$IF=<frequency> to configure the output carrier
macro channel for SIGFOX frames.
Resp :OK
Cmd: AT$IF? To get current value for IF parameter.
Resp: 902800000
Default value = 902200000
AT$DR
Carrier Frequency Macro Channel Configuration
Cmd: AT$DR=<frequency> to configure the reception carrier
macro channel for SIGFOX frames.
Resp :OK
Cmd: AT$DR? to get current value for DR parameter.
Resp :904000000
Default value = 905800000
AT$TR
Set/Get the number of TX repetitions
Parameter is Read-only in the demonstrator
Cmd: AT$TR? to get the current TR parameter value.
Resp : 2
AT$ST
Uplink Test Mode
Cmd : AT$ST=[<count>,<period>,<channel>] : to activate the
test mode :
Resp: OK
count = 0..32767 or -1 : infinite loop sending user frames
(count * burst of 3 frames) : default value : 10
period = 1..255 seconds for sending test frame every period
seconds : default value : 1
channel = 0..480 or -1 : hopping activ