Use and Care Manual

2
ATTACH THE SIDES TO THE CROSSBARS
C
Screw 4,0 x 30mm
C= 6
5/8
2
3
5
7
6
c
c
c
c
c
c
ATTACH ONE SIDE FIRST AND THEN THE OTHER.
• PLEASE CHECK THAT THE DISTANCES
MATCH TO THE SQUARE DIAGRAM.
• SECURE BACK CASTER SUPPORT (PART 6) TO THE LEFT
SIDE (PART 3) USING SCREW (PART C).
SEE THE ROUND DIAGRAM, A BLOW UP IMAGE OF THE SCREW
POSITIONING TROUGH THE ANGLED POCKET HOLES.
• SECURE FRONT CASTER SUPPORT (PART 7) WITH SCREWS
(PART C) TO THE LEFT SIDE (PART 3) IN THE SAME MANNER.
• CAREFULLY TURN LEFT SIDE (PART 3) TO ITS BACK EDGE,
AS SHOWN IN THE DIAGRAM.
• POSITION RIGHT SIDE (PART 2) TO LINE UP THE CROSSBARS
(PART 6 AND 7) AT THE DOWEL HOLES AT BASE OF THE RIGHT SIDE
(PART 2).
• SECURE CASTER SUPPORTS (PART 6 AND 7) TO RIGHT SIDE
(PART 2) USING SCREW (PART C) AND SHOWN IN THE DIAGRAM. TIP:
HAND TIGHTEN FOR THE BEST FIT.
• ATTACH (PART 5) MIDDLE CROSSBAR TO BOTH SIDES OF
THE UNIT AT THE SIDE DRILLED HOLE.
DO NOT USE A DRILL. HAND TIGHTEN.
3
ATTACH THE TOP
Screw 4,0 x 30mm
C= 6
C
1
c
c
c
c
c
•
•
DO NOT STAND LEFT SIDE (PART 3) UP
ON THE EDGE YET. TO EASE ASSEMBLY,
LAY SIDE FLAT ON THE FLOOR, RUNNER
SIDE VISIBLE.
MATCH UP BACK CASTER SUPPORT
(PART 6) AND FRONT CASTER SUPPORT
(PART 7) AT DOWEL HOLES LOCATED AT
THE BOTTOM OF SIDE .
TIP: This
step is
easier with
two people.
TIP: Turning the
unit upside
down provides a
better angle to
tighten the
screws.
• LINE UP THE DOWEL HOLES IN TOP (PART 1)
WITH DOWELS THE IN UNIT´S SIDES.
• SEE ROUND DIAGRAM:
SLIDE (PART C) SCREWS THROUGH ANGLED
POCKET HOLES.
AND HAND TIGHTEN FOR BEST FIT.
127,&(
7+(:5,77(1 ,16758&7,216
CONTAINED +(5(,1$5(&23<5,*+7('