Use and Care Manual

1
8,0 x 30mm
A=12
D=12
A
2
A
A
D
D
D
D
D
PREPARE PARTS FOR ASSEMBLY
• PUSH THE DOWELS (PART A) INTO THE EDGES OF
THE FOLLOWING PARTS, AS SHOWN:
(PART 2) RIGHT SIDE
(PART 3) LEFT SIDE
(PART 6) BACK CASTOR SUPPORT
(PART 7) FRONT CASTOR SUPPORT
ATTACHING DRAWER RUNNERS:
• THE DRAWER RUNNERS (PART D) WILL STRETCH
SLIGHTLY AS YOU HAMMER THEM INTO PLACE.
• LINE UP THE PIPS IN DRAWER RUNNERS (PART D) TO
THE PRE-DRILLED HOLES IN THE RIGHT SIDE PANEL
(PART 2).
• EASE THE PIPS INTO THE HOLES BY TAPPING EACH
PIP DOWN HALF WAY. START ON ONE END, THEN
THE MIDDLE, THEN THE OTHER END.
• WHEN ALL 3 PIPS ARE HALF WAY DOWN AND THE
DRAWER RUNNER (PART D) IS STRETCHED, HAMMER
THE RUNNER ALL THE WAY DOWN UNTIL IT IS FLUSH
WITH THE RIGHT SIDE PANEL (PART 2).
• REPEAT THESE STEPS TO ATTACH THE DRAWER
RUNNERS (PART D) TO THE LEFT SIDE (PART 3).
PREPARE CASTER SUPPORTS:
D
A
A
3
D
D
D
D
D
1st
2nd
3rd
D
6
7
A
(PART Eb).
A
A
A
A
A
A
A
Ea
Eb
Eb
Ea
Eb
Ea
Eb=04
Ea=04
Ea
Eb
Ea
Eb
Dowel
Drawer runner Caster and insert
• USE A HAMMER OR RUBBER MALLET TO
INSERT CASTER INSERT (PART Eb) INTO
THE BOTTOM OF THE FRONT CASTER
SUPPORT (PART 7) AND BACK CASTER
SUPPORT (PART 6).
• TAP ABOVE THE BACK OF THE CASTER
(ABOVE THE STEM) TO ASSEMBLE CASTERS
(PART Ea) INTO THE CASTER INSERT
TIP: Using a regular
hammer to attach the
runners provides a
clearer line of sight than
a rubber mallet.
Perform the entire assembly on a
clean, hard surface using the
flattened box or a towel to protect
the surface and the unit's finish. DO
NOT assemble on carpet.
Carpet creates too much bounce
making assembly difficult and could
lead to damage of the parts.
4-07
NOTICE: 7+(:5,77(1 ,16758&7,216
CONTAINED
+(5(,1$5( &23<5,*+7('