user manual

3.8.2. Normal Mode With Router-LL Conguration Server
• Using the web conguration pages, set up IP address(es), subnet mask(s), and IP gateway
address(es) for the router(s). Connect the router(s) to the same IP network. Using a PC
attached to the network, verify that the routers can be pinged. Consult with the network
administrator to procure the IP address, subnet mask, and gateway address, if not already
known.
• Set the router(s) to normal mode. Set the conguration server address and port to the address
and port of the Router-LL conguration server. e Router-LL conguration server only
communicates on the non-standard port 2009 (not 1629). Set the compatibility type to
Coactive Router-LL. Register the device with the conguration server by clicking on the
Register With Cong Server button. is is done on the Router Setup Page. e device should
now show up in the device list on the Coactive Conguration Server web page.
• Verify that the GRouter device is congured correctly by checking the Channel List on the
router. If congured correctly, the router will have two entries in its Channel List: itself and the
Router-LL.
• e GRouter device and the Router-LLs will now communicate with each other over IP and
will tunnel packets over IP once they have been commissioned using LonMaker or another
compatible management tool.
-72-