Specifications

Chapter 4 - AdeptVision sAVI Option
70 Adept SmartController User’s Guide, Rev. H
Figure 4-1. Two-Camera Breakout Cable for RS-170 Cameras
Four-Camera Breakout Cable for RS-170 Cameras
This cable, available from Adept (P/N 10332-01375) has a 44-pin D-sub connector on one
end, and it breaks out to four 12-pin Hirose-style camera connectors and one 9-pin D-sub
connector on the other end. The length of the cable is 1.8 meters (70 inches).
Dual megapixel camera applications require a four-camera cable since their combined
current draw exceeds the sAVI board's 1 A limit in the absence of external power. An
external 12 V power supply is required for this application.
Similarly, due to the current limitation of the sAVI board, it cannot supply enough current
to operate all four cameras from the four-camera cable. You must supply the external
power to operate the cameras when using this cable. This power must be routed through
the 9-pin D-sub connector, see Figure 4-2 on page 71 and Table 4-2 on page 75 for pin
information. Connect the power and ground on the breakout cable to a 12 V power supply
producing 2.0 A at 12 VDC.
ADEPT
CABLE ASSY. CAMERA INTERFACE 2X
CAM 1
CAM 2
1
31
15
44
To Camera connector on
SmartController CX
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com