Specifications

Chapter 3 - SmartController Operation
58 Adept SmartController User’s Guide, Rev. H
NOTE: The system was evaluated by Underwriters Laboratory with an
Adept Front Panel. If you provide a substitute Front Panel, the system
may no longer be UL compliant.
Customers can build an extension cable to place the Front Panel in a remote location. The
extension cable must conform to the following specifications:
• Wire Size: must be larger than 26 AWG.
• Connectors: must be 15-pin, standard D-sub male and female.
• Maximum cable length is 10 meters.
NOTE: The XMCP and XFP connectors on the SmartController can be
interchanged without electrical damage. However, neither the Front
Panel nor the pendant will work properly unless they are plugged into
the correct connector.
Remote Pendant Usage
Customers can build an extension cable to place the pendant in a remote location. The
extension cable must conform to the following specifications:
• Wire Size: must be larger than 26 AWG.
• Connectors: must be 15-pin, standard D-sub male and female.
• Maximum cable length is 10 meters.
CAUTION: Do not modify the cable that is attached to the
pendant. This could cause unpredictable behavior from
the robot system.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com