User`s guide

Chapter 8: IP-65 Option
c.
Finally push down on the flange to secure it against the housing. See Figure 8-5
for the lower flange in the installed position.
Figure 8-4. Installing Lower Flange Figure 8-5. Lower Flange in Position
5.
Seat all of the cables by pushing down into the foam on the lower flange.
6.
Attach the upper flange to the lower flange using two M6 x 20 screws, two M6 lock
washers, and two M6 flat washers. Make sure none of the cable are pinched or crimped
when installing the upper flange.
7.
Attach the flange assembly using one M6 x 20 screw, one M6 lock washer, and one M6
flat washer. See Figure 8-6.
Figure 8-6. Upper Flange Installed
Figure 8-7. Splash Guard Installed
Adept Cobra ePLC600/800 Robot, User’s Guide, Rev A
Page 93 of 108