User`s guide

Chapter 6: Optional Equipment Installation
Figure 6-9. Solenoid Placement Using Mounting Hardware
9.
Install the appropriate lengths of 5/32 inch plastic tubing (supplied) into the two output
ports on the manifold.
l
Route the tubing up along the tower bracket next to the quill and down through
the center of the quill.
l
Use cable ties as needed to secure the tubing.
10.
Loosen the securing screw on the eAIB chassis, and lower the chassis down flat. See for
the location of the securing screw.
11.
Remove the cable strap plate by removing two screws and split washers. See Figure 6-
10. This allows the harness to move when you lift the J1 cover in the next step.
Adept Cobra ePLC600/800 Robot, User’s Guide, Rev A
Page 79 of 108