User`s guide

Manufacturer’s Declaration
Adept Quattro s650H Robot User’s Guide, Rev A 21
1.3 Manufacturer’s Declaration
The Manufacturer's Declaration of Incorporation and Conformity for Adept robot systems
can be found at the Adept website, under the Support section. The URL for the folder is:
ftp://ftp1.adept.com/Download-Library/Manufacturer-Declarations/
Each Manufacturer's Declaration is supplied in PDF format and stored on the website in a
ZIP archive. To access the PDF document:
1. Click on the appropriate .zip file. You are prompted to Open or Save the file.
2. Click Open to open the file and display the archive contents.
3. Double-click on a .pdf file to open it.
1.4 How Can I Get Help?
Refer to the How to Get Help Resource Guide (Adept P/N 00961-00700) for details on
getting assistance with your Adept software and hardware. Additionally, you can access
information sources on Adept’s corporate web site:
http://www.adept.com
5. Create a 24 VDC cable and connect it between the
robot and the user-supplied 24 VDC power supply.
Section 4.6 on page 54.
6. Create a 200-240 VAC cable and connect it
between the robot and the facility AC power
source.
Section 4.7 on page 57.
7. Install user-supplied safety barriers in the workcell. Section 4.9 on page 61.
8. Connect digital I/O through the XIO connector on
the robot.
Section 5.5 on page 67.
9. Commission the system, including system start-up
and testing operation.
Section 5.6 on page 73.
10.Install optional equipment, including end-effectors,
user air and electrical lines, external equipment,
solenoids, etc.
Section 6.1 on page 81.
Table 1-1. Installation Overview
Task to be Performed Reference Location