User`s guide

Chapter 6: sDIO Module
Panel-Mounting the sDIO Module
To panel-mount the sDIO module, install one bracket on each side of the back of the unit, as
shown in the following figure. Use the screws from the accessories kit.
10.0
18.0
346.4
4x M3 x 6 mm
14.0
6.6
16.0
359.6
27.6
273.9
2x 40356-00000
R 3.6
186.5
Units are mm
Figure 6-3. Panel-Mounting the sDIO Module
Table-Mounting the sDIO Module
To table-mount the sDIO module, install two brackets on each side near the bottom of the unit,
as shown in the following figure.
NOTE:These brackets must be ordered separately. They do not come with the sDIO
module.
Adept SmartController EX User’s Guide, Rev. D
Page 61 of 94