User`s guide

Space Around the Chassis

Adept PA-4 Power Chassis User’s Guide, Rev D 21

Figure 2-1. Installing Mounting Brackets on an Adept PA-4 Chassis

NOTE: See Section 2.3 on page 22 for PA-4 dimensions.

M4 x 10 mm pan-head screw

(2 places)

M4 x 10 mm pan-head screw

(2 places)

M4 x 10 mm pan-head screw

(2 places)

M4 x 10 mm pan-head screw

Rack Mount – Flush

Rack Mount – Set-Back

Panel Mount

To Install Mounting Brackets on Adept PA-4

Power Chassis:

• Remove (and discard) 3 existing countersunk

screws from side of chassis at locations shown

in drawing.

• Place bracket in desired position and secure

with indicated M4 pan-head screws and washers from

accessories kit.

• Repeat process for other side of chassis.