User`s guide

Connections
10 Adept Peripherals User’s Guide, Rev A
2.4 Connecting a Basler GigE Camera
1. Connect the Ethernet cable from the camera to the GigE port on the SmartVision EX.
2. Connect the 12-pin Hirose cable from the camera to the terminal block.
a. Connect the Hirose pink wire to terminal 41 on the terminal block.
b. Connect the Hirose black wire to terminal 1 (signal 1001) on the terminal block.
c. Connect the Hirose brown wire to terminal 42 on the terminal block.
d. Connect the Hirose white wire to terminal 48 on the terminal block.
3. Connect the terminal block DB50 to the SmartController XDIO port.
4. Connect terminal 2 (signal 1001) to terminal 47 on the terminal block with light gauge
wire (16 - 20 AWG).
Components Used:
• Basler GigE camera
• Ethernet cable
• Hirose - unterminated cable, 10 meter
Connects to:
• Adept SmartController CX
• Adept SmartVision EX (GigE PCIe board)
Options:
• DB50 - DB50 Extension Cable (M - F), 5 m
•Terminal Block
• 16 - 20 AWG wire, 0.3 meter
• DB50 - DB50 Cable (M - F), 2 meter
Camera
Basler GigE Camera
pink lead to terminal 41
black lead to terminal 1
wire from terminal
2 to terminal 47
from
Camera
flying
leads
brown lead to terminal 42
white lead to
terminal 48
Terminal Block
(09438-000)
XDIO Port
flying
leads
Hirose Cable
(09450-100)
Hirose
Plug
GigE Port
Ethernet
Cable
DB50-DB50
2 m Cable
(09447-020)
DB50 m
DB50 m
DB50 f
Optional DB50-DB50
5 m Extension
(09447-050)
DB50 f
R
ON
SmartServo IEEE-1394
1 2 3 4
SF ES HD
SW1
1.1 1.2 2.1 2.2
OK
123
XDIO
LANHPE
OFF
XSYS
CAMERA
Eth 10/100
XUSR
Device Net
XFP
RS-232/TERM
RS-232-1
XMCP
BELT ENCODER
SmartController CX
-+ -+
RS-422/485
XDC1 XDC2
24V 5A
*S/N 3562-XXXXX*
RS-232-2
SmartController CX
SmartVision EX