User`s guide

Chapter 2: Robot Installation
Pollution degree 2
Robot protection class IP 20 (NEMA Type 1)
NOTE: For robot dimensions, see Dimension Drawings on page 99.
2.5 Mounting the Robot
WARNING: Only qualified service personnel may install
or service the robot system.
Mounting Surface
The Adept Cobra s600 and s800 robots are designed to be mounted on a smooth, flat, level
tabletop. The mounting structure must be rigid enough to prevent vibration and flexing during
robot operation. Adept recommends a 25 mm (1 in.) thick steel plate mounted to a rigid tube
frame. Excessive vibration or mounting flexure will degrade robot performance. The following
figure shows the mounting hole pattern for the Adept Cobra s600 and s800 robots.
NOTE:On the under side of the base there is a hole and a slot that can be used as
locating points for user-installed dowel pins in the mounting surface; see the
following figure. Using locating pins could improve the ability to remove and
reinstall the robot in the same position.
+0.015
6
2x R4
0
45
50
10
160
160
200
80
90
+0.015
0
Ø 8
4X Ø 14 THRU
6
234
338
Units in mm
Figure 2-2. Mounting Hole Pattern for Robot
Adept Cobra s600/s800 Robot, User’s Guide, Rev L
Page 19 of 126