Specifications

Chapter 5 - 030 Processor Module
64 Adept MV Controller User’s Guide, Rev C
Typical Cable Connections, 9-pin to 25-pin (DTE)
Most terminals and some computers use DTE (Data Terminal Equipment) pinouts.
Remember to enable “modem control” (using
CONFIG_C
) if you are using the DTR, DSR,
RTS, or CTS signals.
Recommended Connections, 9-pin to 25-pin (Wyse WY-60 Terminal)
Adept recommends the use of a Wyse WY-60 terminal on S-Series Adept MV controllers.
The previous table shows a full “7-wire” DTE interface with hardware handshaking (flow
control). The following simplified connections will work with most terminals using DTE
pinouts, such as the Wyse WY-60 terminal. The WY-60 has a female 25-pin connector. This
“3-wire” interface uses software flow control (XON and XOFF control characters).
Table 5-4. Pin Assignments for 9-Pin to 25-Pin (DTE) Cable
9-Pin Female
Pin Number Function
25-Pin DTE
Pin Number Function
— not used 1 Shield
2RXD 2TXD
3TXD 3RXD
4 DTR 6 and 8 DSR and CD
5 Signal ground 7 Signal ground
6 DSR 20 DTR
7RTS 5CTR
8CTS 4RTS
Table 5-5. Pin Assignments for 9-pin to 25-pin (Wyse WY-60 Terminal) Cable
030 RS-232 Wyse WY-60 Terminal
9-Pin Female
Pin Number Function
25-Pin Male
Pin Number Function
— not used 1 Shield
2 RXD 2 TXD
3 TXD 3 RXD
5 Signal ground 7 Signal ground
4
5
6
20
(Pins 4, 5, 6, & 20
linked together)
RTS
CTS
DSR
DTR
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com