Specifications
Chapter 4 - Installation for MV-8 and MV-19 Controllers
54 Adept MV Controller User’s Guide, Rev C
Removing Modules
1. Turn off the controller.
2. Loosen the captive screws at the top and bottom of the module.
3. Lift up on the top handle and push down on the bottom handle as you start to
pull the module out of the chassis. Remove the module from the chassis and store
it in a safe place.
4. If the empty slot is not going to be used again and it is to the left of the last
installed module, you must install five user-supplied jumper plugs onto the five
pairs of jumper pins on the backplane. You can also fill the empty slot by moving
all modules on the right of the unused slot to the left.
CAUTION:
Do not attempt to install or remove any boards without first
turning off the power to the Adept MV Controller and all related external
power supplies. Failure to observe this caution could cause damage to
your equipment.
Installing Modules
1. Turn off the controller.
2. If the slot has a blank panel installed, loosen the captive screws at the top and
bottom of the panel and remove it.
3. Verify that the intended slot for the module is ready to accept the module. If the
slot has been unused, make sure there are no backplane jumper plugs installed for
that slot; see Figure 4-4 and Figure 4-5.
4. Align the module with the card guide slots at the top and bottom of the card cage.
Slide the module in slowly. Apply straight-forward pressure to the two handles
on the outer edge of the module until it is firmly seated in the backplane
connector, and the face of the module is flush with the other modules.
5. Tighten the captive screws at the top and bottom of the module.
CAUTION:
It should not be necessary to use excess pressure or force to
engage the connectors. If the board does not properly connect with the
backplane, remove the module and inspect all connectors and guide slots
for possible damage or obstructions.
4.8 Installing the A-Series Monitor and Keyboard
See section 3.8 on page 34 for installation information.
4.9 Installing a Terminal in an S-Series System
See section 3.9 on page 36 for installation information.
!
!
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com