Specifications

P/N 01332-00050
Rev. A-X1
DECLARATION OF CONFORMITY
We, Adept Technology, with Corporate Headquarters at 150 Rose Orchard Way, San Jose, CA.,
USA, and European Technical Center at Otto-Hahn Str. 23, 44227 Dortmund, Germany,
herewith declare that the:
Controllers MV-5 (P/N 30340-10000 and 30340-30000), MV-8 (P/N 30330-15000),
MV-10 (P/N 30340-20000 and 30340-40000) or MV-19 (P/N 30330-25000),
with/without
Operator’s Manual Control Pendant (MCP III) (P/N 90332-48050)
VME Front Panel Category 1 (P/N90332-00380) or Category 3 (P/N 90335-00380)
in the form delivered by us to which this Declaration relates, comply with the relevant and
fundamental safety and health requirements defined in the EC Directive 89/336/EEC,
Appendix 1, and the following standards:
EN 55011:1991, Class A
EN 50082-2: 1995
EN 60204-1: 1992
IEC 1131-2: 1992
following the provision of Directives:
89/336/EEC
89/392/EEC
73/23/EEC
under the following usage and environmental conditions:
1. The Controller must not be put into operation until all of the machinery into which it is
incorporated has been declared in compliance with the provisions of the effective versions of
the directives. This includes all supplementary equipment and protective devices.
2. The Controller must be used in accordance with instructions specified in the Adept MV
Controller Instruction Handbook.
3. The Controller must incorporate only those MV Plug-in Modules listed in Table 1 or Table 2
attached. If Plug-in Modules listed in Table 2 are installed, the user must verify conformance to
the EMC Directive after installation.
4. This Declaration applies only to those Adept product part-numbers specifically listed in this
declaration. The following changes may result in the system not complying with the applicable
Directives, and would void this declaration unless additional testing and/or evaluation is
performed by the user:
• unauthorized user-modifications;
• substitution or addition of Adept parts not listed on this declaration;
• addition of user-supplied parts and accessories
This Declaration is based upon extensive tests and evaluation by TÜV Rheinland, a Notified and
Competent Body, in their Project Numbers E9372043 and E9572482. The complete File is available at
Adept’s California address.
Place: San Jose, California, USA
Signed:
Date: 18 September 1996
Full Name: Richard J. Casler, Jr.
Position: Vice President, Engineering
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com