Specifications

Appendix E - System Messages
Adept MV Controller User’s Guide, Rev C 231
*Warning* SET.SPEED switch disabled (54)
Explanation: A PRIME operation has been performed from the manual control
pendant while the SET.SPEED system switch is disabled. Therefore, the
monitor speed specified in the PRIME command has no effect.
User action: If you want the PRIME command to change the monitor speed, type the
command enable set.speed at the keyboard.
*Warning* Watchdog timer disabled (56)
Explanation: Displayed at startup by all CPUs if the watchdog timer on the board is
disabled. This timer is a hardware device which asserts SYSFAIL on the
VME bus (which drops high power) if the CPU halts or gets hung. On the
Adept 030 board, the green light goes out if SYSFAIL is asserted.
This message also is displayed whenever user task is started from the
monitor and the watchdog timer is disabled.
User action: Contact Adept Customer Service to verify jumper settings. May also
indicate a hardware fault.
*Wrong disk loaded* (–521)
Explanation: The diskette in a disk drive has been changed while a file was still open.
Further attempts to access the file result in this error. Data being written
into the file may be lost.
User action: Check your diskette to see if any data was lost. If so, it’s too late now. Be
more careful in the future.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com